I am asking this because it is a clone and i don't know what will happen if i load original factory firmware to VCI. THE CRUCIAL QUESTION IS: I have upgraded firmware using *.H86 and *.hex files provided with 2013.1 in 'C:Program Files (x86)Delphi DiagnosticsDS150E (New VCI)Firmware' but do i knead to update new firmware that CAME WITH 2013.3 to work correctly. Is it possible to establish connection with only USB cable connected? In my experience i manage the connection but test and upgrade fails to run.Īlso now I have tried your 2013.3 release but i cannot even get an error with it 'test failed' but it is detected on COM3. Now I have used your installer for cars 2013.1 (all automated) and it worked great form me after firmware upgrade, i managed to run test and upgrade after i connected it to cars OBD to get additional power. (02-07-2014, 04:29 AM)SuperSport Wrote: (02-07-2014, 01:08 AM)tangoman Wrote: how do I get to the com port setting to that must I have the vci plug in to the car and open up the program and do it under setting then hardware can you show me how to do this please thanks for all you help so far your the bestOn Post #1 I added a new video to show how to make the changes.įirst to thank you on all the help with your instructions and installer packages are EXCELLENT.
